Treatment-room light, in one panel

Four wavelengths and 960 LEDs for face and body. One controller can run several lamps at once.

$1,689

Four lights, four depths

Tap each light to see how deep it reaches and which modes use it.

Indicative depth. The manual gives each light's wavelength, not the exact layer.

Red light 630 nmDermis

Reaches the collagen layer. It helps activate cells and build collagen, for firmer, more elastic skin.

Used in these modes

All four modes include 850 nm near infrared. Sessions of 15 to 30 minutes, 3 to 5 times a week.

1Red + infraredFirmness, wrinkles and elasticity.630 nm850 nm
2Yellow + infraredDark spots and uneven tone.590 nm850 nm
3Blue + infraredBreakout-prone skin.415 nm850 nm
4All four lightsA full treatment, with all four lights at once.415 nm590 nm630 nm850 nm

Ideas for your treatment room

Mode per need and treatment-room uses from the Eternas dossier for clinics.

Six steps, just as the manual describes them.

Step 1Cleanse and dry your skinWash the area and pat it dry with a soft towel. Light works best on clean skin.
Step 2Set up the lampFor your face, thread the strap through the holes, bend the panel into an arc and place the headrest in the middle. For the waist or legs, wrap it around the area and adjust the straps.
Step 3Connect and switch onPlug the cable into the controller. Hold the power and mode button for 3 seconds.
Step 4Choose the mode and timeThe power and mode button cycles through four modes. The time button sets 5 to 30 minutes: 15 to 30 is recommended.
Step 5Lie back with your eyes closedWear the goggles in the box and do not look at the light. The brightness button sets it to 50, 75 or 100%.
Step 6Take it off and wipe itWipe it with a damp cloth, never soak it. If you use it in bed, put it back in its box afterwards.